Layout optimization of an inertial energy harvester for miniature underwater mooring platforms

Comprehensive analyses of the layout influence on power performance of a low-frequency miniature horizontal-pendulum-type inertial energy harvester for underwater mooring platforms are presented in this article. The mathematical models are obtained utilizing the Newton-Euler method. The power performance is evaluated by simulations over different parameters, such as damping, excitation frequency, and layout position. Simulation results indicate that the harvester can extract energy from low-frequency excitations over the range of 0.1 Hz–0.4 Hz, and maximum output power can reach to 0.7 W under excitation frequency f = 0.4 Hz. Different layout positions influence the energy harvesting performance of the harvester dramatically. Changing the layout position to positive value can enhance and broaden the power performance. The amplitude responses with different layout positions do not show resonant characteristics, even near the natural frequency of the harvester, due to large amplitude vibrations and strong nonlinear characteristic. As excitation frequency f = 0.4 Hz, there is a zero output power point appears at layout position d = −1.3 m. Moreover, the harnessed power has a quadratic relationship with the layout position value.     

频繁爆破下隧道内振动传播的数值研究

为揭示频繁爆破下隧道内振动传播衰减规律,文章以蒙华铁路段家坪隧道为工程背景,利用LS-DY NA建立了三维隧道模型,模拟分析了多次爆破下隧道内近区和中远区的振动传播规律。结果表明,质点垂向峰值振速随距离和爆破次数的增大而减小,少数振速有增大的现象;近区振动衰减较快,中远区振动衰减比近区缓慢;中远区a值比近区至少小12.5%,但整体上二者的a值随爆破作用次数的增加呈缓慢上升趋势;系数K随爆破作用次数的增加而降低,近区K值降低速率普遍大于中远区,且近区K值比中远区至少大29.1%;频繁爆破下,中远区比近区较符合萨道夫斯基经验公式。     

A carbon footprint-based closed-loop supply chain model under uncertainty with risk analysis: A case study

The management of products’ end-of-life and the recovery of used products has gained significant importance in recent years. In this paper, we address the carbon footprint-based problem that arises in a closed-loop supply chain where returned products are collected from customers. These returned products can either be disposed of or be remanufactured to be resold as new ones. Given this environment, an optimization model for a closed-loop supply chain (CLSC) in which carbon emission is expressed in terms of environmental constraints, i.e., carbon emission constraints, is developed. These constraints aim to limit the carbon emission per unit of product supplied with different transportation modes. Here, we design a closed-loop network where capacity limits, single-item management and uncertainty on product demands and returns are considered. First, fuzzy mathematical programming is introduced for uncertain modeling. Then, the statistical approach to the possibility to synthesize fuzzy information is utilized. Therefore, using a defined possibilistic mean and variance, we transform the proposed fuzzy mathematical model into a crisp form to facilitate efficient computation and analysis. Finally, the risk caused by violating the estimated resource constraints is analyzed so that decision makers (DMs) can trade off between the expected cost savings and the expected risk. We utilize data from a company located in Iran.     

平顺抛石护岸水毁模式及机理

平顺抛石护岸工程在长江中下游应用较为广泛,能够增强堤岸的抗洪能力,保障沿江城乡防洪安全或控制有利河势。然而,护岸块石常常发生滑落导致抛石护岸破坏。针对抛石护岸的水毁破坏问题,进行了抛石护岸实际水毁情况调研及水槽试验研究,认为平顺抛石护岸水毁主要表现为护岸块石的流失、滑落以及岸坡变形,导致坡面土体裸露,提出了抛石护岸的3种水毁破坏模式并分析了相应的破坏机理。     

旁海枢纽工程船闸输水系统布置及试验研究

高水头船闸常采用第二类输水系统以满足船闸闸室内水流条件的要求,但往往工程量大、施工复杂。根据船闸闸址处地形、地质条件,抬高闸底奠基高程以达到降低工程量并简化施工的目的,并在采取一定消能手段后,采用闸墙长廊道侧支孔输水形式。通过物理模型,对旁海航电枢纽输水系统进行布置及优化,证实采取加大闸室初始淹没水深、闸室两侧出水口加设连续消力坎、优化进出水口布置及进水口布置帷墙等措施可达到预期效果。     

盾构法施工单机核算管理模式的应用

近年来盾构机越来越多地应用于各种隧道工程中,其中地铁应用的数量最多,约占80%。现代盾构已演变成为一种高度智能化的大型工程机械装备,对其控制的好坏将直接影响到整个工程的施工成本和企业的经营效益,而通过单机核算降低机械成本是降低施工成本、提高企业效益的有效手段,因此推行盾构法施工单机核算显得尤为重要。文章结合地铁2222标施工项目,重点介绍了盾构法单机核算管理模式及其在施工中的应用。     

气动弹簧在绞吸挖泥船低频振动控制中的应用

针对绞吸挖泥船铰刀旋转切削岩石时产生的低频振动问题,基于气动弹簧的结构形式、受力分析及固有频率低的特点,研究气动弹簧在绞吸挖泥船上的应用方案,并利用船体和生活楼的位移反馈信号控制气动弹簧减振系统的工作状态,同时还介绍了船舶设计过程中需注意的问题。     

基于滑模变结构的船用永磁同步电机直接转矩控制

电力推进在船舶动力系统中应用得越来越多,本文对船用永磁同步电机直接转矩控制进行仿真研究.针对传统永磁同步电机直接转矩控制中存在的磁链和转矩脉动较大,逆变器开关频率不稳定等问题,将滑模变结构控制策略引入.设计转矩和磁链2个滑模控制器,取代传统直接转矩控制中的2个滞环比较器,再运用空间矢量脉宽调制方法,控制电机运行.仿真结果表明这种控制策略能有效减小传统直接转矩控制存在的磁链和转矩脉动,实现逆变器开关频率恒定,并且对系统参数变化及外界扰动具有鲁棒性强的优点.     

乾元公司铁路专用线场站模式探讨

目前,传统的铁路专用线建设模式是铁路专用线自接轨站接轨,通过区间正线引入厂区的建设模式,这种模式的区间正线受地形条件、厂区位置和沿线规划影响较大,这些影响将不可避免地导致铁路专用线建设工程投资的增加,如能根据运输性质考虑缩短区间正线长度,在接轨站旁边设装车作业站,将大大减少专用线工程投资.以乾元公司铁路专用线建设模式为例来研究铁路专用线场站模式,就如何在接轨站旁边设装车作业站,实现接轨站设备与铁路专用线共用进行探讨.     

基于OWA与灰色聚类的城市轨道交通PPP融资风险评价方法研究

针对城市轨道交通PPP融资成本高、投资回收期长、不确定性因素多等特点导致整个融资过程充满风险,且难以进行科学的评价,进而增加风险评价难度的问题,提出基于OWA与灰色聚类的城市轨道交通PPP融资风险评价方法。首先从全寿命周期角度构建城市轨道交通PPP融资风险指标体系。然后基于OWA算子对专家决策数据按照降序的方式重新排序,消除极值带来的不利影响,加权得出指标的权重值。最后考虑指标的灰色性、信息不完整性,构建灰色白化权函数实现指标信息的透明化,完成对PPP融资风险的聚类分析。应用构建的模型对郑州地铁1号线一期工程PPP融资风险进行评价,认为该地铁工程PPP融资风险等级高,应重点关注前期策划、社会资本、政策环境、设计质量、成本超支、建设质量、残值7个主要风险指标的控制,以期为该项目融资风险管理提供建议,并进一步丰富城市轨道交通PPP融资风险的评价方法。